Huawei ECC500 - Connecting the UPS5000-E Monitoring Cable; Connecting the UL33 UPS Monitoring Cable; Connecting the Netcol5000-A Monitoring Cable

ECC500
User Manual
4 Installation and Commissioning
Issue 05 (2020-03-16)
Copyright © Huawei Technologies Co., Ltd.
38
4.3.5.6 Connecting the UPS5000-E Monitoring Cable
Context
The cable connection method described in the section applies to cable connections from the
ports of the RS485 expansion card in the ECC500 to devices.
Procedure
Step 1 Prepare RJ45 connectors on both ends of a network cable, as shown in Figure 4-13.
Step 2 Plug one RJ45 connector to an RS485 port in the ECC500 and the other one to the RS485 port
in the UPS5000-E.
----End
4.3.5.7 Connecting the UL33 UPS Monitoring Cable
Prerequisites
You have obtained an adapter used for transferring an RS232 port to an RS485 port.
Context
The cable connection method described in the section applies to cable connections from the
ports of the RS485 expansion card in the ECC500 to devices.
Procedure
Step 1 Prepare RJ45 connectors on both ends of a network cable, as shown in Figure 4-13.
Step 2 Plug one RJ45 connector to an RS485 port in the ECC500 collector and the other one to the
RS485 port in the adapter.
Step 3 Connect the adapter to the monitoring port in the UL33 UPS.
----End
4.3.5.8 Connecting the NetCol5000-A Monitoring Cable
Context
The cable connection method described in the section applies to cable connections from the
ports of the RS485 expansion card in the ECC500 to devices.
Procedure
Step 1 Prepare RJ45 connectors on both ends of a network cable, as shown in Figure 4-13.
Step 2 Plug one RJ45 connector to an RS485 port in the ECC500 and the other one to the RS485 port
in the NetCol5000-A.
----End