Huawei ECC500 - Adding a UPS5000-E

ECC500
User Manual
5 UI Description
Issue 05 (2020-03-16)
Copyright © Huawei Technologies Co., Ltd.
67
Table 5-3 UPS2000-G parameters
Parameter
Setting
Communication
Board Slot
Select 3 from the drop-down list box.
Communication
Board COM
Select 2 from the drop-down list box.
Equipment Address
In this example, set Equipment Address to 1. Set the actual
device address of the UPS2000-G during operations.
Timeout
The default timeout interval is 2s. Set the parameter to the required
value.
Step 4 Click Add Equipment.
----End
Follow-up Procedure
If the device addition fails, check whether the settings are consistent with the device
parameters.
5.2.4.2 Adding a UPS5000-E
Prerequisites

A UPS5000-E is connected to the ECC500. The UPS5000-E and ECC500 have been
powered on.

You have obtained the ECC500 IP address as well as the user name and password for
WebUI login.

You have prepared a PC which is in the same IP address segment as the ECC500 and
connected the PC to the ECC500 over a switch.
Context
After a UPS5000-E is connected to the ECC500, add the UPS5000-E on the ECC500 WebUI.
Procedure
Step 1 Log in to the ECC500 WebUI.
Step 2 Choose Home > Equipment Manage.
Step 3 Select UPS from the Equipment Type drop-down list box and set device parameters, as
shown in Figure 5-17. Table 5-4 describes the setting methods.