N2000H V3 Appliance
User Guide
4 Configuring the N2000H V3
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Change the default password promptly and change the user password periodically to ensure system
security.
Impact on the System
This operation has no adverse impact on the system.
Prerequisites
Conditions
You have logged in to the iBMC WebUI over a network port. For details, see 7.2 Logging In
to the iBMC WebUI.
Data
Table 4-4 lists the default user name and password of the iBMC.
Table 4-4 Default user name and password
Default User Name
and Password
User name: root
Password:
Huawei12#$
The default user of the iBMC belongs to the administrator group
and has full rights to access all iBMC resources and perform all
operations.
Documents
The following describes how to change a user password on the iBMC WebUI. For details
about how to change a password on the iBMC CLI, see the HUAWEI Rack Appliance iBMC
User Guide.
Procedure
Step 1 In the navigation tree, choose Config > User Settings. In the right pane, click the Local User
tab.
The Local User page is displayed, as shown in Figure 4-17.
After you select Enable for Password Complexity Cheek, the system performs the password
complexity check when a new password is set.
To Next Page
Loading...
Need help?
General