Huawei Quidway S6700 series - Page 114

l # Configure UPE B.
# Enable the RRPP protocol.
[UPEB] rrpp enable
l Configure UPE C.
# Enable the RRPP protocol.
[UPEC] rrpp enable
l Configure PE-AGG.
# Enable the RRPP protocol.
[PE-AGG] rrpp enable
Step 6 Verify the configuration.
After the preceding configurations are complete and the network topology becomes stable,
perform the following operations to verify the configuration. Here, UPE A and PE-AGG are
used as examples.
l Run the display rrpp brief command on UPE A. The following information is displayed:
[UPEA] display rrpp brief
Abbreviations for Switch Node Mode :
M - Master , T - Transit , E - Edge , A - Assistant-Edge
RRPP Protocol Status: Enable
RRPP Working Mode: HW
RRPP Linkup Delay Timer: 0 sec (0 sec default).
Number of RRPP Domains: 2
Domain Index : 1
Control VLAN : major 5 sub 6
Protected VLAN : Reference Instance 1
Hello Timer : 1 sec(default is 1 sec) Fail Timer : 6 sec(default is 6 sec)
Ring Ring Node Primary/Common Secondary/Edge Is
ID Level Mode Port Port Enabled
----------------------------------------------------------------------------
1 0 T XGigabitEthernet0/0/1 XGigabitEthernet0/0/2 Yes
Domain Index : 2
Control VLAN : major 10 sub 11
Protected VLAN : Reference Instance 2
Hello Timer : 1 sec(default is 1 sec) Fail Timer : 6 sec(default is 6 sec)
Ring Ring Node Primary/Common Secondary/Edge Is
ID Level Mode Port Port Enabled
----------------------------------------------------------------------------
1 0 T XGigabitEthernet0/0/1 XGigabitEthernet0/0/2 Yes
You can see that the RRPP protocol is enabled on UPE A.
In domain 1, VLAN 5 is the control VLAN; VLANs mapping instance 1 are the protected
VLANs; UPE A is a transit node on ring 1. The primary port is XGE 0/0/1, and the secondary
port is XGE 0/0/2.
In domain 2, VLAN 10 is the control VLAN; VLANs mapping instance 2 are the protected
VLANs; UPE A is a transit node on ring 1. The primary port is XGE 0/0/1, and the secondary
port is XGE 0/0/2.
l Run the display rrpp brief command on PE-AGG. The following information is displayed:
[PE-AGG] display rrpp brief
Abbreviations for Switch Node Mode :
M - Master , T - Transit , E - Edge , A - Assistant-Edge
Quidway S6700 Series Ethernet Switches
Configuration Guide - Reliability 3 RRPP Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
104