RRPP Protocol Status: Enable
RRPP Working Mode: HW
RRPP Linkup Delay Timer: 0 sec (0 sec default).
Number of RRPP Domains: 2
Domain Index : 1
Control VLAN : major 5 sub 6
Protected VLAN : Reference Instance 1
Hello Timer : 1 sec(default is 1 sec) Fail Timer : 6 sec(default is 6 sec)
Ring Ring Node Primary/Common Secondary/Edge Is
ID Level Mode Port Port Enabled
---------------------------------------------------------------------------
1 0 M XGigabitEthernet0/0/1 XGigabitEthernet0/0/2 Yes
Domain Index : 2
Control VLAN : major 10 sub 11
Protected VLAN: Reference Instance 2
Hello Timer : 1 sec(default is 1 sec) Fail Timer : 6 sec(default is 6 sec)
Ring Ring Node Primary/Common Secondary/Edge Is
ID Level Mode Port Port Enabled
---------------------------------------------------------------------------
1 0 M XGigabitEthernet0/0/2 XGigabitEthernet0/0/1 Yes
The preceding information shows that the RRPP protocol is enabled on PE-AGG.
In domain 1, VLAN 5 is the control VLAN; VLANs mapping instance 1 are the protected
VLANs; PE-AGG is the master node on ring 1. The primary port is XGE 0/0/1, and the secondary
port is XGE 0/0/2.
In domain 2, VLAN 10 is the control VLAN; VLANs mapping instance 2 are the protected
VLANs; PE-AGG is the master node on ring 1. The primary port is XGE 0/0/2, and the secondary
port is XGE0/0/1.
l Run the display rrpp verbose domain command on UPE A. You can obtain the following
results:
# View detailed information about UPE A in domain 1.
[UPEA] display rrpp verbose domain 1
Domain Index : 1
Control VLAN : major 5 sub 6
Protected VLAN: Reference Instance 1
Hello Timer : 1 sec(default is 1 sec) Fail Timer : 6 sec(default is 6 sec)
RRPP Ring : 1
Ring Level : 0
Node Mode : Transit
Ring State : LinkUp
Is Enabled : Enable Is Active : Yes
Primary port : XGigabitEthernet0/0/1 Port status: UP
Secondary port: XGigabitEthernet0/0/2 Port status: UP
The preceding information shows that VLAN 5 is the control VLAN in domain 1 and VLANs
mapping instance 1 are the protected VLANs. UPE A is a transit node in domain 1 and is in
LinkUp state.
# View detailed information about UPE A in domain 2.
[UPEA] display rrpp verbose domain 2
Domain Index : 2
Control VLAN : major 10 sub 11
Protected VLAN: Reference Instance 2
Hello Timer : 1 sec(default is 1 sec) Fail Timer : 6 sec(default is 6 sec)
RRPP Ring : 1
Ring Level : 0
Quidway S6700 Series Ethernet Switches
Configuration Guide - Reliability 3 RRPP Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
105
To Next Page
Loading...
