Huawei Quidway S6700 series - Page 122

7. Configure PE-AGG as the master node and configure UPE A, UPE B, and UPE C as transit
nodes on ring 1 in domain 1 and ring 1 in domain 2.
8. Configure CE1 as the master node and configure UPE B and UPE C as transit nodes on
ring 2 in domain 1 and ring 2 in domain 2.
9. Configure CE2 as the master node and configure UPE B and UPE C as transit nodes on
ring 3 in domain 1 and ring 3 in domain 2.
10. Configure a ring group.
11. Set the link-Up timer.
Data Preparation
To complete the configuration, you need the following data:
l Instance IDs
l Range of the protected VLANs
l IDs of the control VLANs
l Numbers of the RRPP interfaces
l ID of the ring group
l Link-Up-Delay timer
Procedure
Step 1 Create instances.
l Configure CE1.
# Create data VLANs 100 to 300 on CE1.
<Quidway> system-view
[Quidway] sysname CE1
[CE1] vlan batch 100 to 300
# Create instance 1 and map it to control VLANs VLAN 5 and VLAN 6 and data VLANs
100 to 200 in domain 1.
[CE1] stp region-configuration
[CE1-mst-region] instance 1 vlan 5 6 100 to 200
# Create instance 2 and map it to control VLANs VLAN 10 and VLAN 11 and data VLANs
201 to 300 in domain 2.
[CE1-mst-region] instance 2 vlan 10 11 201 to 300
# Activate the configuration.
[CE1-mst-region] active region-configuration
[CE1-mst-region] quit
l Configure CE2.
# Create data VLANs 100 to 300 on CE2.
<Quidway> system-view
[Quidway] sysname CE2
[CE2] vlan batch 100 to 300
# Create instance 1 and map it to control VLANs VLAN 5 and VLAN 6 and data VLANs
100 to 200 in domain 1.
[CE2] stp region-configuration
[CE2-mst-region] instance 1 vlan 5 6 100 to 200
# Create instance 2 and map it to control VLANs VLAN 10 and VLAN 11 and data VLANs
201 to 300 in domain 2.
Quidway S6700 Series Ethernet Switches
Configuration Guide - Reliability 3 RRPP Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
112