0/0/1 secondary-port xgigabitethernet 0/0/2 level 1
[CE2-rrpp-domain-region1] ring 3 enable
[CE2-rrpp-domain-region1] quit
# Configure CE2 as the master node of ring 3 in domain 2. Configure XGE 0/0/2 as the
primary port and XGE 0/0/1 as the secondary port.
[CE2] rrpp domain 2
[CE2-rrpp-domain-region2] ring 3 node-mode master primary-port xgigabitethernet
0/0/2 secondary-port xgigabitethernet 0/0/1 level 1
[CE2-rrpp-domain-region2] ring 3 enable
[CE2-rrpp-domain-region2] quit
Step 5 Enable the RRPP protocol.
After configuring an RRPP ring, you need to enable RRPP on each node on the ring to activate
the RRPP ring. The configuration procedure is as follows:
l Configure PE-AGG.
# Enable the RRPP protocol.
[PE-AGG] rrpp enable
l Configure UPE A.
# Enable the RRPP protocol.
[UPEA] rrpp enable
l Configure UPE D.
# Enable the RRPP protocol.
[UPED] rrpp enable
l # Configure UPE B.
# Enable the RRPP protocol.
[UPEB] rrpp enable
l Configure UPE C.
# Enable the RRPP protocol.
[UPEC] rrpp enable
l Configure CE1.
# Enable the RRPP protocol.
[CE1] rrpp enable
l Configure CE2.
# Enable the RRPP protocol.
[CE2] rrpp enable
Step 6 Configure a ring group.
l Configure UPE C (assistant edge node).
# Create ring group 1, which consists of four subrings: ring 2 in domain 1, ring 3 in domain
1, ring 2 in domain 2, and ring 3 in domain 2.
[UPEC] rrpp ring-group 1
[UPEC-rrpp-ring-group1] domain 1 ring 2 to 3
[UPEC-rrpp-ring-group1] domain 2 ring 2 to 3
[UPEC-rrpp-ring-group1] quit
l Configure UPE B (edge node).
# Create ring group 1, which consists of four subrings: ring 2 in domain 1, ring 3 in domain
1, ring 2 in domain 2, and ring 3 in domain 2.
[UPEB] rrpp ring-group 1
[UPEB-rrpp-ring-group1] domain 1 ring 2 to 3
Quidway S6700 Series Ethernet Switches
Configuration Guide - Reliability 3 RRPP Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
121
To Next Page
Loading...
