EasyManua.ls Logo

Huawei Quidway S6700 series - Page 132

Huawei Quidway S6700 series
295 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
[UPEB-rrpp-ring-group1] domain 2 ring 2 to 3
[UPEB-rrpp-ring-group1] quit
Step 7 Set the link-Up timer.
l Configure CE1.
# Set the link-Up timer to 1 second.
[CE1] rrpp linkup-delay-timer 1
l Configure CE2.
# Set the link-Up timer to 1 second.
[CE2] rrpp linkup-delay-timer 1
l Configure PE-AGG.
# Set the link-Up timer to 1 second.
[PE-AGG] rrpp linkup-delay-timer 1
Step 8 Verify the configuration.
After the preceding configurations are complete and the network topology becomes stable,
perform the following operations to verify the configuration. Here, UPE B and PE-AGG are
used as examples.
l Run the display rrpp brief command on UPE B. The following information is displayed.
[UPEB] display rrpp brief
Abbreviations for Switch Node Mode :
M - Master , T - Transit , E - Edge , A - Assistant-Edge
RRPP Protocol Status: Enable
RRPP Working Mode: HW
RRPP Linkup Delay Timer: 0 sec(default is 0 sec)
Number of RRPP Domains: 2
Domain Index : 1
Control VLAN : major 5 sub 6
Protected VLAN : Reference Instance 1
Hello Timer : 1 sec(default is 1 sec) Fail Timer : 6 sec(default is 6 sec)
Ring Ring Node Primary/Common Secondary/Edge Is
ID Level Mode Port Port
Enabled
-------------------------------------------------------------------------------
--
1 0 T XGigabitEthernet0/0/1 XGigabitEthernet0/0/2 Yes
2 1 E XGigabitEthernet0/0/1 XGigabitEthernet0/0/3 Yes
3 1 E XGigabitEthernet0/0/1 XGigabitEthernet0/0/4 Yes
Domain Index : 2
Control VLAN : major 10 sub 11
Protected VLAN: Reference Instance 2
Hello Timer : 1 sec(default is 1 sec) Fail Timer : 6 sec(default is 6 sec)
Ring Ring Node Primary/Common Secondary/Edge Is
ID Level Mode Port Port
Enabled
-------------------------------------------------------------------------------
--
1 0 T XGigabitEthernet0/0/1 XGigabitEthernet0/0/2 Yes
2 1 E XGigabitEthernet0/0/1 XGigabitEthernet0/0/3 Yes
3 1 E XGigabitEthernet0/0/1 XGigabitEthernet0/0/4 Yes
You can see that the RRPP protocol is enabled on UPE B.
In domain 1:
VLAN 5 is the control VLAN and VLANs mapping instance 1 are the protected VLANs.
Quidway S6700 Series Ethernet Switches
Configuration Guide - Reliability 3 RRPP Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
122

Table of Contents

Related product manuals