EasyManua.ls Logo

Huawei Quidway S6700 series - Page 151

Huawei Quidway S6700 series
295 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
l Configure UPE D.
# Enable the RRPP protocol.
[UPED] rrpp enable
l Configure UPE E.
# Enable the RRPP protocol.
[UPEE] rrpp enable
l Configure UPE F.
# Enable the RRPP protocol.
[UPEF] rrpp enable
l Configure UPE G.
# Enable the RRPP protocol.
[UPEG] rrpp enable
Step 6 Verify the configuration.
After the preceding configurations are complete and the network topology becomes stable,
perform the following operations to verify the configuration. Here, UPE D is taken for example.
l Run the display rrpp brief command on UPE D. The following information is displayed:
[UPED] display rrpp brief
Abbreviations for Switch Node Mode :
M - Master , T - Transit , E - Edge , A - Assistant-Edge
RRPP Protocol Status: Enable
RRPP Working Mode: HW
RRPP Linkup Delay Timer: 0 sec (0 sec default).
Number of RRPP Domains: 3
Domain Index : 1
Control VLAN : major 5 sub 6
Protected VLAN : Reference Instance 1
Hello Timer : 1 sec(default is 1 sec) Fail Timer : 6 sec(default is 6 sec)
Ring Ring Node Primary/Common Secondary/Edge Is
ID Level Mode Port Port Enabled
----------------------------------------------------------------------------
1 0 M XGigabitEthernet0/0/1 XGigabitEthernet0/0/2 Yes
Domain Index : 2
Control VLAN : major 10 sub 11
Protected VLAN : Reference Instance 2
Hello Timer : 1 sec(default is 1 sec) Fail Timer : 6 sec(default is 6 sec)
Ring Ring Node Primary Secondary/Edge Is
ID Level Mode Port Port Enabled
----------------------------------------------------------------------------
1 0 M XGigabitEthernet0/0/2 XGigabitEthernet0/0/1 Yes
Domain Index : 3
Control VLAN : major 20 sub 21
Protected VLAN : Reference Instance 1 to 3
Hello Timer : 1 sec(default is 1 sec) Fail Timer : 6 sec(default is 6 sec)
Ring Ring Node Primary/Common Secondary/Edge Is
ID Level Mode Port Port Enabled
----------------------------------------------------------------------------
1 0 T XGigabitEthernet0/0/3 XGigabitEthernet0/0/4 Yes
The preceding information shows that the RRPP protocol is enabled on UPE D.
In domain 1:
Quidway S6700 Series Ethernet Switches
Configuration Guide - Reliability 3 RRPP Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
141

Table of Contents

Related product manuals