EasyManua.ls Logo

Huawei Quidway S6700 series - 4.3.2 Enabling EFM OAM Globally

Huawei Quidway S6700 series
295 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
VLAN 1 is the control VLAN and VLANs mapping instance 1 are the protected VLANs.
UPE D is the master on ring 1; XGE 0/0/1 is the primary port; XGE 0/0/2 is the secondary port.
In domain 2:
VLAN 10 is the control VLAN and VLANs mapping instance 2 are the protected VLANs.
UPE D is the master node on ring 1. The primary port is XGE 0/0/2, and the secondary port is
XGE 0/0/1.
In domain 3:
VLAN 20 is the control VLAN and VLANs mapping instance 1 to 3 are the protected VLANs.
UPE D is a transit node on ring 1. The primary port is XGE 0/0/3, and the secondary port is
XGE 0/0/4.
l Run the display rrpp verbose domain command on UPE D. You can obtain the following
results:
# View detailed information about UPE D in domain 1.
[UPED] display rrpp verbose domain 1
Domain Index : 1
Control VLAN : major 5 sub 6
Protected VLAN : Reference Instance 1
Hello Timer : 1 sec(default is 1 sec) Fail Timer : 6 sec(default is 6 sec)
RRPP Ring : 1
Ring Level : 0
Node Mode : Master
Ring State : Complete
Is Enabled : Enable Is Active: Yes
Primary port : XGigabitEthernet0/0/1 Port status: UP
Secondary port : XGigabitEthernet0/0/2 Port status: BLOCKED
The preceding information shows that VLAN 1 is the control VLAN in domain 1 and VLANs
mapping instance 1 are the protected VLANs.
UPE D is the master node in domain 1 and is in Complete state.
The primary port is XGE 0/0/1, and the secondary port is XGE 0/0/2.
# View detailed information about UPE D in domain 2.
[UPED] display rrpp verbose domain 2
Domain Index : 2
Control VLAN : major 10 sub 11
Protected VLAN : Reference Instance 2
Hello Timer : 1 sec(default is 1 sec) Fail Timer : 6 sec(default is 6 sec)
RRPP Ring : 1
Ring Level : 0
Node Mode : Master
Ring State : Complete
Is Enabled : Enable Is Active: Yes
Primary port : XGigabitEthernet0/0/2 Port status: UP
Secondary port : XGigabitEthernet0/0/1 Port status: BLOCKED
The preceding information shows that VLAN 10 is the control VLAN in domain 2, and VLANs
mapping instance 2 are the protected VLANs.
UPE D is the master node in domain 2 and is in Complete state.
Quidway S6700 Series Ethernet Switches
Configuration Guide - Reliability 3 RRPP Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
142

Table of Contents

Related product manuals