Huawei Quidway S6700 series - Page 153

The primary port is XGE 0/0/2, and the secondary port is XGE 0/0/1.
# View detailed information about UPE D in domain 3.
[UPED] display rrpp verbose domain 3
Domain Index : 3
Control VLAN : major 20 sub 21
Protected VLAN : Reference Instance 1 to 3
Hello Timer : 1 sec(default is 1 sec) Fail Timer : 6 sec(default is 6 sec)
RRPP Ring : 1
Ring Level : 0
Node Mode : Transit
Ring State : LinkUp
Is Enabled : Enable Is Active: Yes
Primary port : XGigabitEthernet0/0/3 Port status: UP
Secondary port : XGigabitEthernet0/0/4 Port status: UP
The preceding information shows that VLAN 20 is the control VLAN in domain 3 and VLANs
mapping instance 1 to 3 are the protected VLANs.
UPE D is a transit node in domain 3 and is in LinkUp state.
The primary port is XGE 0/0/3, and the secondary port is XGE 0/0/4.
----End
Configuration Files
l Configuration file of UPE A
#
sysname UPEA
#
vlan batch 5 to 6 10 to 11 100 to 300
#
rrpp enable
#
stp region-configuration
instance 1 vlan 5 to 6 100 to 200
instance 2 vlan 10 to 11 201 to 300
active region-configuration
#
rrpp domain 1
control-vlan 5
protected-vlan reference-instance 1
ring 1 node-mode transit primary-port XGigabitEthernet 0/0/1 secondary-port
XGigabitEthernet 0/0/2 level 0
ring 1 enable
rrpp domain 2
control-vlan 10
protected-vlan reference-instance 2
ring 1 node-mode transit primary-port XGigabitEthernet 0/0/1 secondary-port
XGigabitEthernet 0/0/2 level 0
ring 1 enable
#
interface XGigabitEthernet0/0/1
port link-type trunk
port trunk allow-pass vlan 5 to 6 10 to 11 100 to 300
stp disable
#
interface XGigabitEthernet0/0/2
port link-type trunk
port trunk allow-pass vlan 5 to 6 10 to 11 100 to 300
stp disable
#
return
Quidway S6700 Series Ethernet Switches
Configuration Guide - Reliability 3 RRPP Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
143