Huawei Quidway S6700 series

To Next Page

To Previous Page

Figure 6-3 Networking of a VRRP group in master/backup mode

HostB

20.1.1.100/24

XGE0/0/1

SwitchB

Backup

XGE0/0/2

XGE0/0/3

SwitchC

XGE0/0/2

SwitchA

Master

XGE0/0/1

Backup group 1

Virtual IP Address:

10.1.1.111

Ethernet

HostA

10.1.1.100/24

XGE0/0/1

Device Interface VLANIF interface IP address

SwitchA XGE 0/0/1 VLANIF100 10.1.1.1/24

XGE 0/0/2 VLANIF200 192.168.1.1/24

SwitchB XGE 0/0/1 VLANIF100 10.1.1.2/24

XGE 0/0/2 VLANIF400 192.168.2.1/24

SwitchC XGE 0/0/1 VLANIF300 20.1.1.1/24

XGE 0/0/2 VLANIF200 192.168.1.2/24

XGE 0/0/3 VLANIF400 192.168.2.2/24

Configuration Roadmap

The configuration roadmap is as follows:

1. Configure VLANIF interfaces and assign IP addresses to the VLANIF interface.

2. Configure the OSPF protocol between Switch A, Switch B, and Switch C to implement

interworking between them.

3. Create VRRP group 1 on VLANIF 100 of Switch A. Set the highest priority for Switch A

in the VRRP group to ensure that Switch A functions as the master. Configure the

preemption mode on Switch A.

4. Create VRRP group 1 on VLANIF 100 of Switch B and use the default priority.

Data Preparation

To complete the configuration, you need the following data:

Quidway S6700 Series Ethernet Switches

Configuration Guide - Reliability 6 VRRP and VRRP6 Configuration

Issue 01 (2011-07-15) Huawei Proprietary and Confidential

249

Huawei Quidway S6700 series - Page 259