1. Create an instance and add the control VLANs added to the list of protected VLANs.
2. Configure ring 2 of domain 2 on Switch A, Switch B, and Switch C.
3. Configure ring 1 of domain 1 on Switch C, Switch D, and Switch E.
4. Configure Switch A as the master node on ring 2, and configure Switch B and Switch C as
transit nodes on ring 2.
5. Configure Switch E as the master node on ring 1, and configure Switch C and Switch D as
transit nodes on ring 1.
Data Preparation
To complete the configuration, you need the following data.
l Numbers of the RRPP interfaces
l Control VLAN IDs of ring 1 and ring 2
Procedure
Step 1 Create an instance and add the control VLANs added to the list of protected VLANs.
# Configure Switch A.
<Quidway> system-view
[Quidway] sysname SwitchA
[SwitchA] stp region-configuration
[SwitchA-mst-region] instance 2 vlan 20 to 21
[SwitchA-mst-region] active region-configuration
[SwitchA-mst-region] quit
# Configure Switch B.
<Quidway> system-view
[Quidway] sysname SwitchB
[SwitchB] stp region-configuration
[SwitchB-mst-region] instance 2 vlan 20 to 21
[SwitchB-mst-region] active region-configuration
[SwitchB-mst-region] quit
# Configure Switch C.
<Quidway> system-view
[Quidway] sysname SwitchC
[SwitchC] stp region-configuration
[SwitchC-mst-region] instance 1 vlan 10 to 11
[SwitchC-mst-region] instance 2 vlan 20 to 21
[SwitchC-mst-region] active region-configuration
[SwitchC-mst-region] quit
# Configure Switch D.
<Quidway> system-view
[Quidway] sysname SwitchD
[SwitchD] stp region-configuration
[SwitchD-mst-region] instance 1 vlan 10 to 11
[SwitchD-mst-region] active region-configuration
[SwitchD-mst-region] quit
# Configure Switch E.
<Quidway> system-view
[Quidway] sysname SwitchE
[SwitchE] stp region-configuration
[SwitchE-mst-region] instance 1 vlan 10 to 11
Quidway S6700 Series Ethernet Switches
Configuration Guide - Reliability 3 RRPP Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
89
To Next Page
Loading...
Need help?
General
