295
[16] PIO pattern selection (Parameter No.25)
No. Name Symbol Unit Input Range
Default factory
setting
25 PIO Pattern Selection IOPN - 0 to 2, 4 to 6 6
Select an operation pattern.
[Refer to 3.4.10 Control Signals for Remote I/O Mode.]
PIO Patterns 0 to 2, 4 and 5 are available to be selected when Remote I/O Mode is selected.
PIO Pattern 6 can be selected when other than Remote I/O Mode.
Type Set value Mode Feature
PIO
pattern 0
0
Positioning mode
(Standard type)
• Number of positioning points: 64 points
• Position command: Binary code
• Zone signal output: 1 point
• Position zone signal output: 1 point
PIO
pattern 1
1
Teaching mode
(Teaching type)
• Number of positioning points: 64 points
• Position command: Binary code
• Position zone signal output: 1 point
• Jog operation enabled
• Writing current position data to position table
enabled
PIO
pattern 2
2
256-point mode
(Number of
positioning
points256-point
type)
• Number of positioning points: 256 points
• Position command: Binary code
• Position zone signal output: 1 point
PIO
pattern 4
4
Solenoid valve
mode 1
(7-point type)
• Number of positioning points: 7 points
• Position command: Individual No. signal ON
• Zone signal output: 1 point
• Position zone signal output: 1 point
PIO
pattern 5
5
Solenoid valve
mode 2
(3-point type)
• Number of positioning points: 3 points
• Position command: Individual No. signal ON
• Signal equivalent to LS (limit switch) enabled
• Zone signal output: 1 point
• Position zone signal output: 1 point
Other
Remote I/O
Mode
6
• Selectable from the following six types of
modes
1) Simple Direct 2) Positioner 1
3) Direct Number Indication 4) Positioner 2
5) Positioner 3 6) Positioner 5
Refer to Chapter 3. Operation for details.
Chapter 8 Parameter
To Next Page
Loading...
