IBM i Series

iSeries and AS/400e Servers
80 iSeries Handbook
Note 1: Commercial Processing Workload (CPW) is used to measure the performance of all iSeries and AS/400e
processors announced from September 1996 onward. The CPW value is measured on maximum
configurations. The type and number of disk devices, the number of workstation controllers, the amount of
memory, the system model, other factors, and the application running determine what performance is
achievable.
Note 2: The total number of tape drives does not increase.
Note 3: There must be one CD-ROM or DVD-RAM per system.
Note 4: One line is used if #5544 System Console on Operations Console is used. One line might be used if the #5546
or #5548 System Console on LAN is selected and the #0367 Operations Console Cable is connected.
Note 5: Includes the #5034 or #5035 tower and all the SPD bus towers attached to the #5034 or #5035.
Note 6: Includes the #5077 tower and all the SPD bus towers attached to the #5077.
Note 7: New systems only, does not apply to migrated towers.
Note 8: Includes base CD-ROM in Migration tower (no feature code).
Note 9: Processor Group is determined by a combination of the Processor and Interactive Feature. The following table
provides a cross reference.
Processor Interactive Feature Processor Feature Processor Group
#2400
#1531 #23C1 P20
#1532 #23C2 P30
#1533 #23C3 P30
#1534 #23C4 P30
#1535 #23C5 P30
#2402
#1531 #23D1 P30
#1532 #23D2 P40
#1533 #23D3 P40
#1534 #23D4 P40
#1535 #23D5 P40
#1536 #23D6 P40
#2403
#1531 #23D8 P40
#1532 #23D9 P50
#1533 #23DA P50
#1534 #23DB P50
#1535 #23DC P50
#1536 #23DD P50
#1537 #23DE P50