iSeries Model SB3 237
iSeries Model SB3
– Memory Control Regulator (CCIN 2716)
– Processor Regulators (CCIN 2714) (Quantity two)
– Charger
– Battery Pack
– SPCN Card (CCIN 285E)
– AC Power Supply Country Specific Usage
• Processor side, 24 Way
– Bulks (1000 watt) (CCIN 5154) (Quantity five)
– Programmable Regulators (CCIN 2730) (Quantity nine)
– Memory Control Regulator (CCIN 2716)
– Processor Regulators (CCIN 2714) (Quantity two)
– Charger
– Battery Pack
– SPCN Card (CCIN 285E)
– AC Power Supply Country Specific Usage
• Base I/O Tower (#9079)
– Bulks (765 Watt) (CCIN 515A) (Quantity two)
– Batteries (Quantity four)
– AC Input/Charger
• Dual Line Cord - SB3 CEC (#5104)
– Provides dual line cord capability for the Model SB3 system unit and #9079 base I/O
tower.
– Two #14XX line cords are required on the Model SB3 and the #9079 when this feature
is ordered initially. When ordering #5104 alone as an MES, an additional 14XX line
cord is required for the system unit, and for the #9079, for a total of two line cords on
both the system unit and the #9079.
– OS/400 V5R1 and supporting PTFs are required. Refer to Informational APAR II12950
at:
http://as400service.rochester.ibm.com/supporthome.nsf/document/10000035
– e-configurator users can refer to this Web site for ordering information:
http://w3-1.ibm.com/sales/systems/ibmsm.nsf/MainFrameset?OpenForm&cdoc=idlcinstall
#9079 Base I/O Tower
The #9079 is the base I/O tower shipped on the Model SB3. The #9079 supports up to eight
disk units, up to 11 PCI IOAs, and up to two removable media units.
Select two (any combination) of these HSL cables:
• #1460 - 3m Copper HSL cable
• #1461 - 6m Copper HSL cable
• #1462 - 15m Copper HSL cable
To Next Page
Loading...
