To Next Page

To Previous Page

iSeries and AS/400e Servers

84 iSeries Handbook

Note 1: Commercial Processing Workload (CPW) is used to measure the performance of all iSeries and AS/400e

processors announced from September 1996 onward. The CPW value is measured on maximum

configurations. The type and number of disk devices, the number of workstation controllers, the amount of

memory, the system model, other factors, and the application running determine what performance is

achievable. With the introduction of the Dedicated Servers for Domino, Simple Mail Users is added as a

performance measurement.

Note 2: The total number of tape drives does not increase.

Note 3: There must be one CD-ROM or DVD-RAM per system.

Note 4: One line is used if the #5544 System Console on Operations Console is used. One line might be used if the

#5546 or #5548 System Console on LAN is selected and the #0367 Operations Console Cable is connected.

Note 5: Includes the #5077 and all the SPD Bus towers attached to the #5077.

Note 6: New systems only. Does not apply to migrated system.

Note 7: Includes base CD-ROM in Migration tower (no feature code).

Note 9:

External DASD maximum assumes 17.54 GB LUNs. External DASD cannot exceed the maximum system

capacity or the maximum number of disk arms.

Note 8: Processor Group is determined by a combination of the Processor and Interactive Feature. The following table

provides a cross reference.

Processor Interactive Feature Processor Feature Processor Group

#2416

#1540 #24C0 P40

#1541 #24C1 P50

#1542 #24C2 P50

#1543 #24C3 P50

#1544 #24C4 P50

#1545 #24C5 P50

#1546 #24C6 P50

#2417

#1540 #24C8 P40

#1541 #24C9 P50

#1542 #24CA P50

#1543 #24CB P50

#1544 #24CC P50

#1545 #24CD P50

#1546 #24CE P50

IBM i Series Handbook

Other manuals for IBM i Series