IBM i Series

iSeries Model 820
146 iSeries Handbook
• #5546 – System Console on 100Mbps Token Ring
#2744 PCI 100Mbps Token Ring Adapter (Console)
• #5548 – System Console on Op Console (Default)
#4838 PCI 100/10Mbps Ethernet IOA (Console)
These required features must be purchased:
• Processor (one must be specified)
– #0150 processor (SStar 600 Mhz Uni) (1100 CPW)
– #0151 2-wayprocessor (SStar 600 Mhz) (2350 CPW)
– #0152 4-way processor (SStar 600 Mhz) (3700 CPW)
– #2435 processor (SStar 600 Mhz Uni) (600 CPW)
– #2436 processor (SStar 600 Mhz Uni) (1100 CPW)
– #2437 2-way processor (SStar 600 Mhz) (2350 CPW)
– #2438 4-way processor (SStar 600 Mhz) (3700 CPW)
• Interactive Card (one must be specified)
• Main Storage (a minimum of two of the same features must be selected)
– #3009 - 128 MB Main Storage (default - maximum of 8 DIMMs of this type per system)
– #3004 - 256 MB Main Storage (128 Mb technology)
– #3005 - 512 MB Main Storage (128 Mb technology)
– #3006 - 512 MB Main Storage (256 Mb technology)
– #3007 - 1 GB Main Storage (256 Mb technology)
Note: Feature codes 3005 and 3006 can neither be mixed within pairs nor within quads.
• Integrated Disk Units
Device Parity Protection: All (#0041) is the default for disk data protection. With RAID
protection as the default, a minimum of four disk units of equal capacity must be ordered.
If RAID protection is removed from the system order, order at least one of these disks:
Processor Feature #0150 #0151 #0152 #2435 #2436 #2437 #2438
Interactive Feature
#1521
#1522
#1523
#1524
#1525
#1526
#1527
None
-
None
-
None
-
35
70
120
240
35
70
120
240
560
35
70
120
240
560
1050
35
70
120
240
560
1050
2000