To Next Page

To Previous Page

Summary of Earlier AS/400, AS/400e, and iSeries Models 785

Summary of Earlier AS/400, AS/400e, and iSeries Models

Note 1: CPW is the Commercial Processing Workload that is now being used to measure the performance of all

iSeries and AS/400e processors. The CPW value is measured on maximum configurations. The type and

number of disk devices, the number of workstation controllers, the amount of memory, the system model, other

factors, and the application being run determine the performance that is achievable. All iSeries and AS/400e

processors announced from September 1996 onward have only CPW performance measurements.

Note 2: This total includes the MFIOP. The combination of internal and external IOPs cannot exceed this number.

Note 3: The maximum combination of 2440, 7208 or 9348 and Tape Libraries may not exceed four.

Note 4: The Processor Group is determined by a combination of Processor and Interactive Feature. The following

table provides a cross reference.

Processor Interactive Feature System Feature Code Processor Group

#2065

#1506 2A6A P20

#1507 2A6B P30

#1508 2A6C P30

#1509 2A6D P30

#2066

#1506 2A6E P20

#1507 2A6F P30

#1508 2B6A P30

#1509 2B6B P30

#1510 2B6C P30

#2067

#1506 2B6D P30

#1508 2B6E P40

#1509 2B6F P40

#1510 2C6A P40

#1511 2C6B P40

#2068

#1506 2C6C P30

#1508 2C6D P40

#1509 2C6E P40

#1510 2C6F P40

#1511 2D6A P40

Note 5: The system maximum for internal tapes and CD-ROMs is 18.

IBM i Series Handbook

Other manuals for IBM i Series