30 IBM z13s Technical Guide
DPM provides simplified, consumable, and enhanced partition lifecycle and dynamic I/O
management capabilities by using the Hardware Management Console and is designed to
perform these tasks:
Create and provision an environment:
– Create new partitions
– Assignment of processors and memory
– Configuration of I/O adapters (Network, FCP Storage, Crypto, and Accelerators)
Manage the environment: Modify system resources without disrupting running workloads
Monitor and troubleshoot the environment: Source identification of system failures,
conditions, states, or events that can lead to workload degradation.
A CPC can be in either the DPM mode or the standard PR/SM mode.
DPM mode is enabled before the CPC power-on reset.
Operating the CPC in DPM mode requires two OSA-Express 1000BASE-T Ethernet ports
(recommended that these be on separate features) for primary and backup SE
connectivity.
1.8 Operating systems and software
IBM z13s servers are supported by a large set of software, including independent software
vendor (ISV) applications. This section lists only the supported operating systems. Use of
various features might require the latest releases. For more information, see Chapter 7,
“Software support” on page 229.
1.8.1 Supported operating systems
The following operating systems are supported for z13s servers:
z/OS Version 2 Release 2 with program temporary fixes (PTFs)
z/OS Version 2 Release 1 with PTFs
z/OS Version 1 Release 13 with PTFs
z/OS V1R12 with required maintenance (compatibility support only) and extended support
agreement
z/VM Version 6 Release 4 with PTFs (preview)
z/VM Version 6 Release 3 with PTFs
z/VM Version 6 Release 2 with PTFs
KVM for IBM z Systems Version 1.1.1
z/VSE Version 6 Release 1 with PTFs
z/VSE Version 5 Release 2 with PTFs
z/VSE Version 5 Release 1 with PTFs
z/TPF Version 1 Release 1 with PTFs