9
UPDATING THE FIRMWARE
9-5
2. Unzipping the rmware folder
1. Right-click the downloaded firmware folder (zip format).
2. Click “Extract All...”
• After unzipping, a folder is created in the same location as the downloaded folder.
L In the “R30_X*” folder, “R30EXXX.dat*” is created.
* X represents the release number.
3. Connect the IC-R30 to a PC
1. Connect the IC-R30 to a PC using the supplied USB cable.
2. Turn ON the receiver power.
L Do not remove the microSD card from the receiver.
4. Enter the SD Card mode
You can access the data on the microSD card, through a USB cable.
[MENU] > Function > USB Connect > SD Card Mode
1. Push [MENU].
2. Select “SD Card Mode” in the “Function” menu.
(Rotate [DIAL] to select it, then push [ENTER].)
• A conrmation dialog appears.
3. Select “YES.”
• Displays the IC-R30 folder on the PC screen.
4. Copy the downloaded firmware data into the IC-R30 folder on the SD card.
Copy
5. After the SD card removal operation (p. 2-8), disconnect the IC-R30 from the
PC.
■ Updating the rmware (Continued)
To Next Page
Loading...
