Icom IC-R30 - Page 65

5
GPS OPERATION
5-17
■ GPS Memory
D Adding a GPS Memory (Continue)
5. Entering the GPS Memory latitude
1. Select “LATITUDE.”
2. Push D-pad (Right) or D-pad (Left) to move the cursor
to select a digit to enter.
3. Rotate [DIAL] to set the latitude.
L Information
• Set to between 0°00.00’ to 90°00.00’.
• You can change the unit to “ddd°mm’ss”.” (p. 6-24)
• To enter a north latitude, select “N,” and to enter a south
latitude, select “S.”
4. Repeat steps 2 and 3 to enter the latitude.
5. After entering, push [ENTER].
L Returns to the GPS MEMORY EDIT screen.
6. Entering the GPS Memory longitude
1. Select “LONGITUDE.”
(Rotate [DIAL] to select it, and then push [ENTER].)
2. Push D-pad (Right) or D-pad (Left) to move the cursor
to select a digit to enter.
3. Rotate [DIAL] to enter the longitude.
L Information
• Range: Set to between 0°00.00’ to 180°00.00’.
• You can change the unit to “ddd°mm’ss”.” (p. 6-24)
• To enter an east longitude, select “E,” and to enter a west
longitude, select “W.”
4. Repeat steps 2 and 3 to enter the longitude.
5. After entering, push [ENTER].
L Returns to the GPS MEMORY EDIT screen.
7. Entering the GPS Memory altitude
1. Select “ALTITUDE.”
2. Rotate [DIAL] to select plus or minus.
3. Push D-pad (Right) or D-pad (Left) to move the cursor
to select a digit to enter.
4. Rotate [DIAL] to set the altitude.
L Set to between –32808 and +32808 feet.
5. Repeat steps 3 and 4 to enter the altitude.
6. After entering, push [ENTER].
L Returns to the GPS MEMORY EDIT screen.