Icom ID-51A Advanced Instructions

9
D-STAR OPERATION <ADVANCED>
9-30
Repeater list programming (Continued) ■
Position data accuracy level setting11.
When the Repeater Search function is not used, or
the distance between your position and a repeater is
not displayed, select “OFF.”
$4 Push D-pad() to select “POSITION,” and then push
D-pad(Ent).
D-pad
(�)
(Ent)
$5 Push D-pad() to select the position data accuracy
level.
• None : Select when the repeater has no position
data.
• Approximate : Select when the programmed position data
is approximate.
• Exact : Select when the programmed position data
is exactly correct.
$6 After setting, push D-pad(Ent).
Latitude programming12.
This item appears only when “Approximate” or “Ex-
act” is selected in [11. Position data accuracy level
setting].
$7 Push D-pad() to select “LATITUDE,” and then push
D-pad(Ent) to enter the latitude data edit mode.
• A cursor appears and blinks.
$8 Rotate [DIAL] to input the latitude.
$9 Push to move the cursor backward, or push to
move the cursor forward.
%0 Repeat steps $8 and $9 to enter the latitude.
%1 After entering, push D-pad(Ent).
Longitude programming13.
This item appears only when “Approximate” or “Ex-
act” is selected in [11. Position data accuracy level
setting].
%2 Push D-pad() to select “LONGITUDE,” and then
push D-pad(Ent) to enter the longitude data edit
mode.
• A cursor appears and blinks.
%3 Rotate [DIAL] to input the longitude.
%4 Push to move the cursor backward, or push to
move the cursor forward.
%5 Repeat steps %3 and %4 to enter the longitude.
%6 After entering, push D-pad(Ent).
☞ Continued on the next page.
Previous view

Icom ID-51A Specifications

General

Frequency Range	144-148 MHz, 430-450 MHz
Antenna Connector	SMA
GPS Receiver	Yes
Waterproof	IPX7
Modes	FM, DV
Weight	255 g
Memory Channels	1304 channels
Output Power	5W (High), 2.5W (Middle), 0.5W (Low)