2
USING A microSD CARD
2-15
Updating the repeater list (Continued) ■
!2 Push D-pad(Ent) to select the file, and then the “Keep
'SKIP' settings in Repeater List?” appears.
!3 Push D-pad() to select “YES” or “NO.”
• When “YES” is selected, the skip settings of the repeater
list are retained. (p. 9-36)
!4 Push D-pad(Ent), “Load le?” appears.
!5 Push D-pad() to select “YES,” then push D-pad(Ent)
to start the file check.
• While checking the le, “CHECKING FILE” and a prog-
ress bar are displayed.
!6 After checking, settings data loading starts.
• While loading, “LOADING” and a progress bar are dis-
played.
!7 After loading, “COMPLETED!” appears.
To complete the loading, reboot the transceiver.
Repeater list updating is complete!
To Next Page
Loading...
