Icom ID-51A

14
PRIORITY WATCH
14-4
Checks the selected priority channel every 5 seconds,
while receiving on a VFO frequency.
Set the VFO frequency1.
q Push [V/MHz]
to select the VFO mode.
w Rotate [DIAL] to set the receive frequency.
Set the priority channel2.
• In case of the Memory channel
q Push [M/CALL]
to select the Memory mode.
w Rotate [DIAL] to select the Memory channel you
want to watch.
• In case of the Bank channel
q Push [M/CALL] to select the Memory mode.
w Rotate [DIAL] to select the Bank channel you
want to watch.
HowtoselecttheMemoryandBank:
z In the Memory mode, push [QUICK]
.
x Push D-pad() to select “Bank Select,” and
then push D-pad(Ent).
• The Bank list is displayed.
c Push D-pad() to select a desired bank and
then push D-pad(Ent).
• If “OFF” is selected, cancel the bank selection.
D-pad
(�)
(Ent)
• In case of the Call channel
q Push [M/CALL] one or more times to select
the Call channel mode.
w Rotate [DIAL] to select the Call channel you want
to watch.
Start the Priority scan3.
q Push [QUICK]
.
w Push D-pad() to select “PRIO Watch,” and then
push D-pad(Ent).
e Push D-pad() to select “ON” or “Bell.”
• ON : When a signal is received on the priority
channel, the channel is automatically se-
lected.
• Bell : When a signal is received on the priority
channel, the “ ” icon is displayed in the
VFO mode.
r Push D-pad(Ent) to start the Priority scan.
• The “PRIO” icon appears
NOTE:
• You can set the priority channel (Step 2) before set-
ting the VFO frequency (Step 1).
• Push [CLR] to cancel the Priority scan.
■ VFO frequency and a priority channel
[DIAL]
Example: Checks Memory channel “490” every 5 sec-
onds, while receiving on 145.800 MHz.
Continued on the next page. ☞
Rotate [DIAL] to set the
receive frequency.
Push [M/CALL] .
Rotate [DIAL] to select
the Memory channel.
Push [QUICK]
.
Push D-pad() to
select, then push
D-pad(Ent).
Push D-pad() to
select, then push
D-pad(Ent).
Previous view