Icom ID-51A

14
PRIORITY WATCH
14-5
Blinks
Automatically selects the priority channel.
Remains the VFO mode.
During the Priority scan4.
Checks the selected priority channel every 5 seconds,
while receiving on a VFO frequency.
When a signal is received5.
• When “ON” is selected.
When a signal is received on the priority channel,
the channel is automatically selected.
The “PRIO” icon blinks on the screen.
- The scan pause timer and resume settings are the
same as for a normal scan. (p. 16-18)
• When “Bell” is selected.
When a signal is received on the priority channel,
a beep sounds and the “
” icon blinks on the
screen.
Example:
Checks M-CH “490” while receiving on 145.800
MHz frequency.
Example: Checks Bank CH “D06” while receiving on
145.800 MHz frequency.
Example: Checks Call CH “C3” while receiving on 145.800
MHz frequency.
Example: In case of the Memory channel
Appears
Checks the Memory chan-
nel every 5 seconds.
VFO frequency and a priority channel (Continued) ■
Appears
Appears Appears
Appears Appears
Priority channel
Priority channel
Priority channel
Blinks
Checks the Bank channel
every 5 seconds.
Checks the Call channel
every 5 seconds.
Previous view