Icom ID-51A

14
PRIORITY WATCH
14-10
■ VFOscanandMemory/Bankscan
Blinks
Example:
Sequentially c hecks the memory channels ev-
ery 5 seconds during a VFO scan.
Sequentially checks the Memory or Bank channels ev-
ery 5 seconds during a VFO scan.
StarttheMemoryorBankscan1.
• In case of the Memory scan
q Push [M/CALL]
to select the Memory mode.
w Hold down [SCAN] for 1 second.
e Push D-pad() to select the scan type, and
then push D-pad(Ent) to start the Memory scan.
(p. 13-9)
D-pad
(�)
(Ent)
•IncaseoftheBankscan
q Push [M/CALL] to select the Memory mode.
w Hold down [SCAN] for 1 second.
e Push D-pad() to select the scan type, and
then push D-pad(Ent) to start the Bank scan.
(p.13-10)
How to select the Memory and Bank:
z In the Memory mode, push [QUICK]
.
x Push D-pad() to select “Bank Select,” and
then push D-pad(Ent).
 •TheBanklistisdisplayed.
c Push D-pad() to select a desired bank and
then push D-pad(Ent).
 •If“OFF”isselected,cancelthebankselection.
Start the Priority scan2.
q Push [QUICK]
.
w Push D-pad() to select “PRIO Watch,” and then
push D-pad(Ent).
e Push D-pad() to select “ON” or “Bell.”
  •ON :Whena signalis received onthe priority
channel, the channel is automatically se-
lected.
  •Bell:Whena signalis received onthepriority
channel, the “ ” icon is displayed in the
VFO mode.
r Push D-pad(Ent) to start the Priority scan.
  •The“PRIO”iconappears
Continued on the next page. ☞
Push [M/CALL] .
Hold down [SCAN]
for 1 second.
Push D-pad() to
select, then push
D-pad(Ent).
Blinks
Push [QUICK]
.
Push D-pad() to
select, then push
D-pad(Ent).
Push D-pad() to
select, then push
D-pad(Ent).
Previous view