Icom ID-51A Advanced Instructions

16
MENU SCREEN
16-5
NOTE: The default settings shown below are for the USA version.
The default settings may differ, depending on your transceiver version.
Menu items and Default settings (Continued) ■
QSO Recorder <<REC Start>>*
Play Files*
Recorder Set
Player Set
PLAY FILES
REC Mode
RX REC Condition
File Split
PTT Auto REC
Skip Time
In this item, set the TX/RX voice recording options.
TX&RX or RX Only
Always or Squelch Auto
OFF or ON
OFF or ON
3sec, 5sec, 10sec or 30sec
DV Auto Reply*
Voice Memo
DESCRIPTIONS
RANGE OR VALUE (Default is shown in bold)
Selects whether or not the squelch status
affects the RX voice audio recording.
Turns the PTT Automatic Recording func-
tion ON or OFF.
Sets the Skip time to rewind or forward the
recorded audio when you push the fast-re-
wind or fast-forward key during playback.
Selects whether or not to automatically
create a new file if transmission and re-
ception, or squelch status (open and
close) is switched.
Selects to record the TX audio or not.
Plays or deletes the recorded audio.
Starts recording the received signal audio.
Records a voice audio to use the Auto
Reply function in the DV mode.
Voice Recorder Record *
Play Files*
PLAY FILES
1, 2, 3 or 4
Sets the microphone sensitivity to suit
your needs.
Plays or deletes the recorded audio.
Starts recording the microphone audio.
Player Set
Skip Time
3sec, 5sec, 10sec or 30sec
Sets the Skip time to rewind or forward the
recorded audio when you push the fast-re-
wind or fast-forward key during playback.
* Be sure to insert the microSD card into the transceiver before selecting these items.
Record *
TX Set Repeat Time
In this item, set the microphone voice recording options.
1sec~5sec~15sec
OFF or ON
Voice TX
DESCRIPTIONS
RANGE OR VALUE (Default is shown in bold)
The TX Monitor function outputs the TX
voice audio from the speaker during voice
transmission.
Sets the repeat interval. The transceiver
repeatedly transmits the recorded voice
audio at this interval.
Starts recording the microphone audio.
<<Single TX>> *
<<Repeat TX>> *
TX Monitor
Recorder Set
MIC Gain
The transceiver transmits the recorded
voice audio only one time.
The transceiver repeatedly transmits the
recorded voice audio for a maximum of
10 minutes.
*
Be sure to insert the microSD card into the transceiver before selecting these items.
Previous view

Icom ID-51A Specifications

General

Frequency Range	144-148 MHz, 430-450 MHz
Antenna Connector	SMA
GPS Receiver	Yes
Waterproof	IPX7
Modes	FM, DV
Weight	255 g
Memory Channels	1304 channels
Output Power	5W (High), 2.5W (Middle), 0.5W (Low)