Icom ID-51A Advanced Instructions

3
PANEL DESCRIPTION
3-4
!8 CS (CALL SIGN SELECT)/D-PAD (RIGHT) KEY
[CS]/D-pad()
➥ Hold down for 1 second to enter the oper-
ating call sign select mode.
➥ While in the DR mode, or with the Menu
screen or Quick Menu screen open, push
to select a lower tier menu. (p. 16-2)
!9 RXÚCS (RX CALL SIGN CAPTURE)/D-PAD (UP)
KEY [RXÚCS]/D-pad()
➥ Hold down for 1 second to set the received
call signs (station and repeaters) as the
operating call sign.
• While holding down this key, rotate [DIAL] to
select another call sign in the RX history.
➥ While in the DR mode, or with the Menu
screen or Quick Menu screen open, push
to move the value or option selector bar up.
(p. 16-2)
@0 EXTERNAL MICROPHONE/SPEAKER JACK
[MIC/SP]
Connect a cloning cable, optional speaker micro-
phone or headset, if desired.
See Section 18 for a list of available options.
Be sure to turn OFF the power before connecting
or disconnecting optional equipment to or from
the [MIC/SP] jack.
@1 VOLUME CONTROL [VOL]
Rotate to adjust the audio volume level. (p. 5-2)
@2 CONTROL DIAL [DIAL]
Rotate to select the operating frequency. (p. 5-6) ➥
While in the Memory mode, rotate to select a ➥
memory channel. (p. 12-3)
While scanning, rotate to change the scanning ➥
direction. (p. 13-3)
Hold down [SQL], and rotate to select the squelch ➥
level. (p. 5-6)
While in the DR mode, or with the Menu screen ➥
or Quick Menu screen open, rotate to select a de-
sired option or value.
Front, top and side panels (Continued) ■
q
w
r
u
i
o
!0
e
t
y
!1
!2
!3
!4
!5
!6
!7
!8
!9
Function
display (p. 3-5)
Internal
microphone
Speaker
@0
@1
@2
Previous view

Icom ID-51A Specifications

General

Frequency Range	144-148 MHz, 430-450 MHz
Antenna Connector	SMA
GPS Receiver	Yes
Waterproof	IPX7
Modes	FM, DV
Weight	255 g
Memory Channels	1304 channels
Output Power	5W (High), 2.5W (Middle), 0.5W (Low)