3
PANEL DESCRIPTION
3-3
!2 DR (D-STAR REPEATER)/D-PAD (DOWN) KEY
[DR]/D-pad()
➥ Hold down 1 second to enter the DR mode.
(p. 8-3)
➥ While in the DR mode, or with the Menu
screen or Quick Menu screen open, push
to move the value or option selector bar
down. (p. 16-2)
!3 EXTERNAL DC IN JACK [DC IN]
Connects to the supplied wall charger, BC-167SA/ ➥
SD/SV, to charge the attached battery pack. (p. 4-3)
Connect an external DC power supply through ➥
the optional CP-12L or CP-19R cigarette lighter
cable or OPC-254L DC power cable for external
DC operation. (p. 4-6)
!4 DATA JACK [DATA]
Connects to a PC through the optional OPC-2218LU
data communication cable, for low-speed data com-
munication in the DV mode or for cloning. The jack is
also used to connect an external GPS receiver.
See page 9-14 or 17-17 for more details.
!5 QUICK MENU • SPEECH KEY [QUICK SPCH]
➥ Push to enter or exit the Quick Menu
screen. (p. 5-4)
• The Quick Menu is used to quickly select vari-
ous functions.
➥ Hold down for 1 second to audibly an-
nounce the displayed frequency, operating
mode or call sign. (p. 17-6)
!6 MEMORY/CALL • SELECT MEMORY WRITE KEY
[M/CALL•S.MW]
➥ In the VFO mode, push once to enter the
Memory selection mode, push again to en-
ter the Call channel mode. (p. 8-3)
For ID-51A only
In the Call channel mode, push once to
enter the Weather channel mode.
➥ Hold down for 1 second to enter the Select
Memory Write mode. (p. 12-4)
!7 VFO/MHz • CLEAR • OUTPUT POWER KEY
[VFO/MHz•CLR•LOW]
➥ Push to select the VFO mode. (p. 5-8)
➥ While in the VFO mode, push to select
1 MHz and 10 MHz tuning steps. (p. 5-6)
➥ With the Menu screen or Quick Menu screen
open, push to return to the operating mode
before entering the menu screen. (p. 16-2)
➥ While in the Memory Name or Call Sign
Programming mode, push to delete the
character. (p. 12-11)
➥ While scanning, push to cancel a scan.
(pp. 13-5, 13-9)
➥ Hold down for 1 second to select the out-
put power. (p. 5-10)
• Select the transmit output power of High, Mid,
Low2, Low1 or S-low.
• While holding down this key, rotate [DIAL] to
select the desired output power.
Front, top and side panels (Continued)
■
q
w
r
u
i
o
!0
e
t
y
!1
!2
!3
!4
!5
!6
!7
!8
!9
Function
display (p. 3-5)
Internal
microphone
Speaker
@0
@1
@2
To Next Page
Loading...
Need help?
General
