16
MENU SCREEN
16-20
Scan items (Continued) ■
Program Link (Default: Refer to the diagram below)
Scan > Program Link (Program Link)
This item sets the link function for more than two pair of Program Scan Edge
channels to be sequentially scanned during the Program Link Scan.
The link function scans all frequencies in the scan range.
Default settings of the Program Link
The Program Scan Edge channels “01” and “02” are set in the Program Link
number “0” as the Default.
...
Program Link 0：
1：
9：
Edit Name
01：144.000−148.000
Program Link number (0〜9)
Blank
Program Scan Edge channel
02：420.000−450.000
• The Program Link number screen shows the frequency range. (The scan edge fre-
quency may differ, depending on the transceiver version.)
• A link setting can be added when more than two pairs of Program Scan Edge chan-
nels are programmed. (p. 13-2)
Push
Program Link number screen
NOTE: The “Add” item will not be displayed when only one pair of pro-
grammed scan edge channels are programmed, or no programmed scan
channel (00 to 24) is left to add to the selected link channel.
Adding a Scan Edge channel to the Program Link
q
Push D-pad() to select a Program Link number between 0 and 9, where you
wish to add a Scan Edge channel, and then push D-pad(Ent).
Push [QUICK] w .
e Push D-pad() to select “Add,” and then push D-pad(Ent).
r Push D-pad() to select a programmed scan number you wish to assign
to the selected link channel, and then push D-pad(Ent).
(For example: 00: 144.000-450.000)
Push [MENU] t to exit the [MENU] screen.
To Next Page
Loading...
Need help?
General
