Icom ID-51A

17
OTHER FUNCTIONS
17-25
• Digital code squelch setting
Command : 1B 07
XX
q
First digit: 0–9 Second digit: 0–9
• DV MY call sign setting
Command : 1F 00
Set your own call sign and note of up to 12 characters.
XX XXXXXXXXXX
o–!2q–i
• • •
q–i : Your own call sign setting (8 characters)
o–!2 : Note setting (4 characters)
• DV TX call signs setting (24 characters)
Command : 1F 01
Set “UR,” “R1” and “R2” call signs of 8 characters (fixed).
XX
• • •
XX XXXX X XXX
• • •
!7–@4o–!6q–i
• • •
q–i: UR (Destination) call sign setting (8 characters)
o–!6: R1 (Access/Area repeater) call sign setting (8 char-
acters)
!7–@4: R2 (Link/Gateway repeater) call sign setting (8
characters)
• Character’s code of the call sign
Character ASCII code
0–9 30–39
A–Z 41–5A
(Space) 20
/ 2F
• DV TX message setting
Command : 1F 02
Set the transmit message of up to 20 characters.
“FF” stops sending or reading messages.
Character ASCII code Character ASCII code
A–Z 41–5A a–z 61–7A
0–9 30–39 Space 20
! 21 # 23
$ 24 % 25
& 26 \ 5C
? 3F " 22
’ 27 ` 60
^ 5E + 2B
– 2D
✱
2A
⁄ 2F . 2E
, 2C : 3A
; 3B = 3D
< 3C > 3E
(
28
)
29
[
5B
]
5D
{
7B
}
7D
¦
7C
_
5F
¯ 7E @ 40
• DV RX Status setting
Command : 20 0201, 20 0202
Data Function Description
bit7 0 (Fixed) —
bit6 0/1 Receiving a
voice call
During receiving a digital voice
signal, select “1.” (Regardless of
DSQL and CSQL setting)
bit5 0/1 Last call finisher When the last call was finished
by you, select “1.”
bit4 0/1 Receiving a
signal
When the audio tone can be
heard, select “1.”
bit3 0/1 Receiving a BK
call
During receiving a BK call, select
“1.”
bit2 0/1 Receiving a
EMR call
During receiving a EMR call,
select “1.”
bit1 0/1 Receiving a
signal other than
DV
When “DV” and “FM” are blinking,
select “1.”
bit0 0/1 Packet loss
status
During displaying a packet loss
CI-V information (Continued) ■
Previous view