IDEC SmartRelay functions
IDEC SmartRelay Manual 189
Scaling an analog input value
You can influence the analog input value of a potentiometer
by interconnecting an analog input with an analog amplifier
and an analog memory marker.
• Scale the analog value at the analog amplifier for further
use.
• Connect, for example, the time base for parameter T of a
t
ime function (e.g.
On-/Off-delay, Chapter 4.4.3) or the on
and/or off limit specification of an up/down counter
(Cha
pter 4.
4.13) to the scaled analog value.
For more information with programming examples refer to
the online h
elp for WindLGC.
Setting the Par parameter
The gain and offset parameters are used to adapt the
sensors to the r
elevant application.
View in programming mode (example):
To Next Page
Loading...
