IDEC SmartRelay functions
132
IDEC SmartRelay Manual
Functional description
You can configure the pulse/interpulse width at the T
H
(Time
High) and T
L
(Time Low) parameters.
Input Inv can be used to invert the output signal, provided the
block is enabled with a signal at input EN.
If retentivity is not set, output Q and the expired time are re-
set after a power failure.
Courtesy of Steven Engineering, Inc. ● 230 Ryan Way, South San Francisco, CA 94080-6370 ● General Inquiries: (800) 670-4183 ● www.stevenengineering.com
To Next Page
Loading...
