Programming IDEC SmartRelay
80
IDEC SmartRelay Manual
If you are sure that you want to delete the circuit program
from memory:
5. Move the ‘>’ cursor to ‘Yes’: Press ▲ or ▼
6. Press OK.
7. Enter your password.
8. Press OK. The circuit program is deleted.
Note
Although you may have forgotten your password, you can still de-
lete the circuit program by entering the wrong password three
times.
3.6.12 Summertime/wintertime conversion
You can enable or disable automatic Summertime/winter-
time conversion in programming mode by calling the “Clock”
menu command.
1. Switch the IDEC SmartRelay to programming mode.
2. You are now in the main menu and want to select the
‘Clock’ menu command: Press ▲ or ▼
3. Confirm ‘Clock’: Press OK
4. Move the ‘>’ cursor to ‘S/W Time’: Press ▲ or ▼
5. Confirm ‘S/W Time’: Press OK
Password?
ZZ
To prevent unintentional deletion
of your circuit program, you are
prompted to enter your password
(provided you have assigned
one).
Courtesy of Steven Engineering, Inc. ● 230 Ryan Way, South San Francisco, CA 94080-6370 ● General Inquiries: (800) 670-4183 ● www.stevenengineering.com
To Next Page
Loading...
Need help?
General
