IDEC SmartRelay Series - Deleting the Circuit Program

Programming IDEC SmartRelay
IDEC SmartRelay Manual 79
3.6.11 Deleting the circuit program
To delete a circuit program:
1. Switch the IDEC SmartRelay to programming mode
2. On the main menu, press ▲ or ▼ to move the ‘>’ cursor
to ‘Program’. Press OK.
3. Move the ‘>’ cursor to ‘Clear Prg’: Press ▲ or ▼
4. Confirm ‘Clear Prg’: Press OK
To cancel deletion of the circuit program, leave the ‘>’ cursor
at ‘No’ and press OK.
>Program..
Card..
Clock..
Start
IDEC SmartRelay opens the
main menu
>Edit..
Clear Prg
Password
IDEC SmartRelay changes to the
programming menu
Clear Prg
>No
Yes
Courtesy of Steven Engineering, Inc. ● 230 Ryan Way, South San Francisco, CA 94080-6370 ● General Inquiries: (800) 670-4183 ● www.stevenengineering.com