Applications
246
IDEC SmartRelay Manual
8.6 Luminous rows
When planning lighting systems for commercial locations,
the type and number of lamps used is determined by the lu-
minance required. For reasons of cost efficiency, the instal-
lation often consists of fluorescent tubes arranged in lumi-
nous rows, and are divided into separate switching circuits,
according to the way the room is used.
8.6.1 Requirements for a lighting system
• The various luminous rows are switched on and off local-
ly.
• If there is sufficient daylight, the rows on the window side
of the room are automatically switched off by means of a
daylight control switch.
• The lights are switched off automatically at 20.00 h.
• Local manual operation of the lighting must be possible
at all times.
Luminous rows 1
Luminous rows 2
Luminous rows 3 Luminous rows 4
Office
Corridor
Courtesy of Steven Engineering, Inc. ● 230 Ryan Way, South San Francisco, CA 94080-6370 ● General Inquiries: (800) 670-4183 ● www.stevenengineering.com
To Next Page
Loading...
Need help?
General
