Configuring IDEC SmartRelay
IDEC SmartRelay Manual 199
5.1.1 Parameters
Note
In the following discourse on parameters, we presume that the re-
spective default parameter protection mode (“+”) has been main-
tained. This is prerequisite for viewing and editing parameter in the
parameter assignment mode! See Chapter 4.3.5 and the example
on page 109.
Parameters are, for example:
• The delay times of a time relay.
• The switching times (cams) of time switch.
• Counter thresholds
• The monitoring time for hour counters
• The trigger thresholds.
Each one of the parameters is identified by its block number
(Bx) and the shortname of the parameter. Examples:
• T:...is a configurable time.
• MI:...is a configurable time interval.
Note
WindLGC also allows you to assign names to blocks (for more in-
formation, refer to Chapter 7).
Courtesy of Steven Engineering, Inc. ● 230 Ryan Way, South San Francisco, CA 94080-6370 ● General Inquiries: (800) 670-4183 ● www.stevenengineering.com
To Next Page
Loading...
