EasyManua.ls Logo

IDEC SmartRelay Series - Selecting Parameter Assignment Mode

IDEC SmartRelay Series
297 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Configuring IDEC SmartRelay
IDEC SmartRelay Manual 197
5.1 Selecting parameter assignment mode
Press ESC to change from RUN to parameter assignment
mode:
Note
The following applies to earlier device versions up to 0BA2:
You open parameter assignment mode by pressing
ESC+OK.
IDEC SmartRelay changes to parameter assignment mode
and opens the parameter assignment menu:
2003-01-27
Mo 09:00
ESC
Press
>Stop
Set Param
Set Clock
Prg Name
Courtesy of Steven Engineering, Inc. ● 230 Ryan Way, South San Francisco, CA 94080-6370 ● General Inquiries: (800) 670-4183 ● www.stevenengineering.com

Table of Contents

Related product manuals