Programming IDEC SmartRelay
IDEC SmartRelay Manual 81
IDEC SmartRelay shows the following display:
The current setting of automatic S/W Time conversion is
shown in the bottom row. The default setting is ‘Off’: dis-
abled.
Enabling summertime/wintertime conversion
You now want to enable this conversion and define or set its
parameters:
1. Move the ‘>’ cursor to ‘On’: Press ▲ or ▼
2. Confirm ‘On’: Press OK
The display shows:
3. Select the desired conversion: Press ▲ or ▼
What is shown on the display?:
•‘EU’ represents the start and end of European summer-
time.
•‘UK’ represents the start and end of summertime in the
United Kingdom.
•‘US’ represents the start and end of summertime in the
United States.
•‘AUS’ represents the start and end of Australian summer-
time.
•‘AUS-TAS’ represents the start and end of Australian/
Tasmanian summertime.
•‘NZ’ represents the start and end of New Zealand sum-
mertime.
• . . : Here you can enter any month, day and time zone dif-
ference.
Courtesy of Steven Engineering, Inc. ● 230 Ryan Way, South San Francisco, CA 94080-6370 ● General Inquiries: (800) 670-4183 ● www.stevenengineering.com
To Next Page
Loading...
