IDEC SmartRelay installation and wiring
12
IDEC SmartRelay Manual
• Do not connect an external power supply in parallel to the
output load of a DC output. This could develop a reverse
current at the output if you have not installed a diode or
similar barrier device.
Note
IDEC SmartRelay units may only be installed and wired by
skilled personnel who know and follow the general engineer-
ing rules and the relevant regulations and standards.
Courtesy of Steven Engineering, Inc. ● 230 Ryan Way, South San Francisco, CA 94080-6370 ● General Inquiries: (800) 670-4183 ● www.stevenengineering.com
To Next Page
Loading...
