IDEC SmartRelay memory cartridge (card)
IDEC SmartRelay Manual 215
Note
Before you switch the IDEC SmartRelay to RUN, you must ensure
that the system you are controlling with IDEC SmartRelay does not
represent a source of hazard.
1. Move the ‘>’ cursor to ‘Start’: Press ▲ or ▼
2. Press OK.
Copying by means of the “Card” menu
For information on the replacement of a memory cartridge
(card), also note Chapter 6.2.
To copy a program from the memory cartridge (card) to IDEC
SmartRelay:
1. Insert the memory cartridge (card)
2. Switch the IDEC SmartRelay to programming mode
(ESC / >Stop).
3. Move the ‘>’ cursor to ‘Card’: Press ▲ or ▼
4. Press OK. The transfer menu opens.
5. Move the ‘>’ cursor to ‘Card → IDEC SmartRelay’:
Press ▲ or ▼
6. Press OK.
IDEC SmartRelay copies the circuit program from the mem-
ory cartridge (card) to IDEC SmartRelay. When IDEC Smar-
tRelay has finished copying, it automatically returns to the
main menu.
>Program..
Card..
Clock..
Start
= IDEC
SmartRelay
Card
>Card
CopyProtect
Courtesy of Steven Engineering, Inc. ● 230 Ryan Way, South San Francisco, CA 94080-6370 ● General Inquiries: (800) 670-4183 ● www.stevenengineering.com
To Next Page
Loading...
Need help?
General
