IDEC SmartRelay without display
276
IDEC SmartRelay Manual
Operating status indication
Operating states, e.g. Power On, RUN and STOP are indi-
cated by an LED on the front hood.
• Red LED: Power On/STOP
• Green LED: Power On/RUN
The red LED is lit after Power On and in all IDEC SmartRelay
states other than RUN. The green LED is lit when IDEC
SmartRelay is in RUN mode.
Reading current data
WindLGC (see Chapter 7) provides an online test for reading
the current data of all functions while the system is in RUN.
If your IDEC SmartRelay without display holds a protected
memory cartridge (card), you can not read the current data
unless you enter the correct password for your the circuit
program. The circuit program is otherwise deleted from
IDEC SmartRelay memory when you remove the memory
cartridge (card) to connect the PC cable, for example (see
Chapter 6.1).
Courtesy of Steven Engineering, Inc. ● 230 Ryan Way, South San Francisco, CA 94080-6370 ● General Inquiries: (800) 670-4183 ● www.stevenengineering.com
To Next Page
Loading...
Need help?
General
