Programming IDEC SmartRelay
40
IDEC SmartRelay Manual
A small example in the first part of this chapter introduces the
operating principle of IDEC SmartRelay.
• We shall first show you the meaning of two basic terms,
namely the connector and the block.
• In the next step, we shall create a circuit program based
on a simple conventional circuit, which you ...
• can enter directly in IDEC SmartRelay in the third step.
It will take you only a few pages of this manual store your first
executable circuit program in the IDEC SmartRelay unit.
With a suitable hardware (switches etc.), you will then be
able to carry out first tests.
Courtesy of Steven Engineering, Inc. ● 230 Ryan Way, South San Francisco, CA 94080-6370 ● General Inquiries: (800) 670-4183 ● www.stevenengineering.com
To Next Page
Loading...
