Programming IDEC SmartRelay
IDEC SmartRelay Manual 51
Rule 3
Cursor and cursor movement
The following applies when you edit a circuit program:
• You can move the cursor when it appears in the form of
an underscore:
- Press , , ▼ or ▲ to move the cursor in the circuit
program.
- Press OK to change to "Select connector/block"
- Press ESC to exit programming mode.
• You select a connector/block
• when the cursor appears as solid square
- Press ▼ or ▲ to select a connector or a block.
- Confirm with OK.
- Press ESC to return to the previous step.
Rule 4
Planning
• Before you start to create a circuit program, you should
either first create design on paper or program IDEC
SmartRelay directly using WindLGC.
• IDEC SmartRelay can only save complete and faultless
circuit programs.
▲
▲
Courtesy of Steven Engineering, Inc. ● 230 Ryan Way, South San Francisco, CA 94080-6370 ● General Inquiries: (800) 670-4183 ● www.stevenengineering.com
To Next Page
Loading...
