IEMCA KID 80 - Operating Cycle Description

EN
3 - INFORMATION FOR SET UP KID 80 SIV
3 - Pag. 14 / 26
OPERATING CYCLE - DESCRIPTION
START
Feedings
The bar feeder sends the
last piece machining end
signal to the lathe, the
lathe enters the bar change
subprogram and sends the
open collet and bar change
signals
EJECTION
ADVANCES
Phase
1
Phase
2
Phase
3
Movement to
position 0 at low
speed and Chk zero
position sensor if
ok carry on
Phase
4
Phase
5
Phase
6
**