EN
3 - INFORMATION FOR SET UP KID 80 SIV
3 - Pag. 2 / 26
3.1 PROTECTED PARAMETERS: DISPLAY
These parameters refer to the bar feeder configuration and the bar feeder-lathe interfacing. The
modification procedure is mainly necessary during the installation of the bar feeder by an
authorized technician.
Data entering or modifying in these parameters is possible only by using the special data
entering mode.
To access this mode, it is necessary to follow the procedure given in Section 4.2. The pages of
this section are only supplied to the technician authorized by the manufacturer.
WARNING - CAUTION
The parameters are set to a default value (preset value): the bar feeder
performs the automatic cycle according to these values.
The main display modes are the following:
- Access the protected parameters
- Display the protected parameters
- Display the protected subparameters
- Exit the protected parameters
To Next Page
Loading...
