1 - BASE INFORMATION KID 80 SIV
EN
1 - Pag. 3 / 15
1.1 CONTROL DESCRIPTION
INFORMATION:
From the hand-held keyboard it is possible to automatically start the bar feeder,
even when the Lathe ‘MAN/AUT' signal is in Manual mode.
INFORMATION:
When the bar feeder is in Automatic mode, the bar feeding is possible only when
the Lathe "MAN/AUT" signal is in Automatic mode.
INFORMATION:
By pressing the Manual mode button on the handheld keyboard it is possible to
prevent the bar feeder Automatic start by the lathe.
INFORMATION:
Manual control by keyboard is displayed on the screen. if the control is not
correct, in the keyboard screen a message describing the correct procedure is
displayed.
To Next Page
Loading...
