IEMCA KID 80 - Program Identification Data: Display Mode

EN
2 - INFORMATION FOR USE KID 80 SIV
2 - Pag. 66 / 66
2.13 PROGRAM IDENTIFICATION DATA: DISPLAY MODE
The following four programs have been installed in the bar feeder:
- Push-button panel firmware;
- Push-button panel software;
- PLC/NC Software.
For many reasons (for example the request of assistance) it could be useful to display and
understand the program identification data of these programs using the following procedure.
To display the programme identification data of the "Push-button panel Firmware"
1. Turn off the electrical supply.
2. Turning the electrical supply on again, the following
screen will appear on the display for a few seconds:
identification data of the push-button panel
firmware: UniOP XX XX
To display the identification data of the "Push-button panel software" of the "PLC/NC
Software".
1. Enter the data entering mode:
[pupa_kid_barra_oriz-sx]
2. Display the screen:
the display shows:
identification data of the push-button panel software: [barra] SwOP:xxxxx [barra]
PLC/NC software identification data: [barra] SwCNC:xxxxx [barra]
UniOP XX XX
OPERATION MODE
---[ xxxxx ]---
SwOP: xxxxx
SwCNC:xxxxx