IEMCA KID 80 - Information for Use

2 - INFORMATION FOR USE KID 80 SIV
EN
2 - Pag. 1 / 66
INDEX
2.1 AUTOMATIC CYCLE START ....................................................................................... 2
2.2 0-AXIS PROCEDURE (MANUAL MODE) ....................................................................... 4
2.3 CYCLE PERFORMING MODE IN THE STEP-BY-STEP FUNCTION ................................... 5
2.4 BAR FEEDER STOP ................................................................................................... 8
2.5 OPERATOR PARAMETERS: OPERATION MODE ........................................................... 9
2.6 PARAMETER ACCESSING AND DISPLAY ................................................................... 10
2.6.1 Access to and display of common parameters .......................................................... 10
2.6.2 HOW TO ACCESS AND DISPLAY IEMCA PARAMETERS .............................................. 12
2.7 PARAMETER MODIFICATION .................................................................................. 14
2.8 SUBPARAMETERS DISPLAY ..................................................................................... 15
2.9 SUBPARAMETER MODIFICATION ............................................................................ 16
2.10 EXITING THE PARAMETERS .................................................................................... 17
2.11 OPERATOR PARAMETERS: DESCRIPTION ................................................................ 17
2.12 ERRORS - CAUSES - SOLUTIONS ............................................................................ 54
2.12.1 OPERATOR PANEL MESSAGE LIST .......................................................................... 64
2.12.2 CONDITIONS THAT MAY CAUSE A GENERIC ALARM ON THE LATHE ......................... 65
2.13 PROGRAM IDENTIFICATION DATA: DISPLAY MODE ................................................. 66